How To Install A Kitchen Sink And Faucet

The sink and faucet are very durable but bear a lot of wear, bumps, scrapes, and contact with cleaning agents that can cause them to lose brightness. Therefore, it must be renewed. The correct and less heavy thing is that you mount the drain valve, fastening clips, sealing putty, and then tap with its hoses in the sink before installing it on the countertop. Work will be safer and more accessible.

Step 1

It would help if you first chose the sink you want. If you are going to replace an old one, it must be the same size not to be rectified on the countertop and it must be done by experts like https://climatecontrolexperts.com/plumbing/  to avoid problems in the future. If the countertop is new, you will have it more accessible because you can adapt the hole to the sink more to your liking.

1. Prepare the sink’s valve according to the type of drain you have, usually related to the same diameter. Disassemble each of its parts with a screwdriver.
2. Place the valve itself under the sink and, on the sinus side, the sealing gasket and the valve mouth. With a manual screwdriver, tighten the valve, ensuring that it is well fixed and centered within the drain
3. Place the overflow according to the chosen model and adapted it to the type of sink. One part goes in the drain valve, and the other, with a watertight gasket, in the grate where the water would overflow if the sink fills up.
4. Don’t forget to tighten the overflow on the inside of the breast with a screwdriver.
5. Now, place the corresponding clips on the metal profile prepared for it at the bottom of the sink. Place those recommended by the manufacturer, depending on the size of the sink. Staples are usually pressed fit.
6. Next, you must put the sealing tape or putty that may be included with the sink or buy it independently. Alternatively, a silicone bead can be applied.
7. Prepare the faucet. Insert the two hoses into their corresponding holes, one for the hot water outlet and the other for the cold water outlet.
8. You must also insert one or two threaded tightening rods or rods, depending on the tap’s model.
9. Insert the rubber gasket and its corresponding clamping plate on the tap’s stem or stems.
10. Hand-in the screw (s) that will end up holding the faucet tightly to the surface of the sink.
11. The final tightening of the screw is done on most tap models with a socket wrench, usually 12 mm. This operation can be finished from below once the sink is placed on the worktop

Steps 2

Place The Sink

1. Place the sink in the hole in the counter. Be careful with the staples so they don’t damage the countertop. Be careful to have a new square stopcock on hand because you may notice small leaks, and you need a change when handling the old ones. You are also interested in having new longer hoses so that they adapt well to the measurements of your shots or small ones to lengthen those of the faucet kit.
2. Squeeze each staple under the counter. Use a manual or cordless screwdriver. You will notice how the sink is perfectly imprisoned to it.
3. Now position the tap well at the top of the sink, depending on the model of your tap. Check that the spout will fall where it belongs. Finish tightening the clamping nuts from the bottom.
4. Now, place the hoses on each of the square stopcocks. Remember, on the left, the one for hot water and the right that of cold water.
5. Tighten first by hand and finally with a wrench.
6. Attach the drain to the sink valve. Everything will be ready to use.
7. Open the two stopcocks and the tap and check that there is no leak.